Geometry optimization to increase the flux control range of a double excitation synchronous motor

Archive ouverte : Communication dans un congrès

Hoang, Trung-Kien | Vido, L | Gillon, F | Gabsi, M.

Edité par HAL CCSD

International audience. This paper deals with a structural optimization to improve the open circuit flux control capability of a double excitation synchronous motor. In this kind of motor, the air-gap flux varies according to the field current. It can be weakened or enhanced when decreasing or increasing the field current. For a specific machine geometry, minimum and maximum air-gap flux are found at certain field currents. It is, therefore, desirable to minimize the minimum flux and maximize the maximum one to improve the controlling effectiveness of the field windings. That objective is the focus of this paper through a structural optimization. The machine is modeled by using an equivalent magnetic circuit network. Some interesting points on the non-dominated pareto front will be verified against ones obtained with the 3-D finite element method.

Consulter en ligne

Suggestions

Du même auteur

Comparison between a Double Excitation Synchronous Machine and a Permanent Magnet Synchronous Machine According to Various Constant Power Speed Ranges | Hoang, Trung-Kien

Comparison between a Double Excitation Synchronous Machine and a Permanent ...

Archive ouverte: Communication dans un congrès

Hoang, Trung-Kien | 2017-04-11

International audience. This paper presents a comparison between a Double Excitation Synchronous Machine (DESM) and a Permanent Magnet Synchronous Machine (PMSM). Optimal designs of both machine types are compared r...

Thermal analysis of a double excitation synchronous machine | Hoang, Trung-Kien

Thermal analysis of a double excitation synchronous machine

Archive ouverte: Communication dans un congrès

Hoang, Trung-Kien | 2017-07-04

International audience. In this paper, a thermal analysis of a synchronous machine using the double excitation principle is presented. Two global field windings introduce not only a more complicated structure but al...

Correction to “Flux Control Range Broadening and Torque Ripple Minimization of a Double Excitation Synchronous Motor” [Jan 17 Art. no. 8100510] | Hoang, Trung-Kien

Correction to “Flux Control Range Broadening and Torque Ripple Minimization...

Archive ouverte: Article de revue

Hoang, Trung-Kien | 2017-05

International audience. I N [1], an error in Fig. 2 in Section II-B is corrected. In the original figure, Fig. 2(b) was exactly the same as Fig. 2(a). The correction is shown here. Fig. 2. RN model of the prototype....

Du même sujet

Thermal analysis of a double excitation synchronous machine | Hoang, Trung-Kien

Thermal analysis of a double excitation synchronous machine

Archive ouverte: Communication dans un congrès

Hoang, Trung-Kien | 2017-07-04

International audience. In this paper, a thermal analysis of a synchronous machine using the double excitation principle is presented. Two global field windings introduce not only a more complicated structure but al...

Investigation on Model Predictive Control of a Five-Phase Permanent Magnet Synchronous Machine under Voltage and Current limits | Kestelyn, Xavier

Investigation on Model Predictive Control of a Five-Phase Permanent Magnet ...

Archive ouverte: Communication dans un congrès

Kestelyn, Xavier | 2015-03

The optimal control of electrical drives necessitates to take into account current and voltage limits that are imposed by the power electronics and the electrical machines. Let’s cite for example the flux-weakening operation of el...

Inverter Fault Diagnosis of an Electrical Series-Connected Two Sinusoidal Six-Phase Permanent Magnet Machines Drive | Jose dos Santos Moraes, Tiago

Inverter Fault Diagnosis of an Electrical Series-Connected Two Sinusoidal S...

Archive ouverte: Article de revue

Jose dos Santos Moraes, Tiago | 2020-03-08

International audience. This paper investigates a real-time fault diagnostic of a transportation system which needs two drives with fault-tolerance capabilities. Because of constraints on the mass of the system and ...

Two-Slot Coil Pitch For Five-Phase Integrated Permanent Magnet Synchronous Machine | Cousseau, R.

Two-Slot Coil Pitch For Five-Phase Integrated Permanent Magnet Synchronous ...

Archive ouverte: Communication dans un congrès

Cousseau, R. | 2020-08

International audience. This paper presents a simple method to size a concentrated winding permament magnet synchronous machine when a high number of slots is needed. A classical concentrated winding machine leads t...

Design Considerations of Five-Phase Machine with Double p/3p Polarity | Gong, Jinlin

Design Considerations of Five-Phase Machine with Double p/3p Polarity

Archive ouverte: Article de revue

Gong, Jinlin | 2018

International audience. In the context of traction drives with required torque transient capabilities and a classically wide flux weakening speed range, this paper gives design considerations of a particularDouble-P...

Quantitative Design of a High Performance Permanent Magnet Vernier Generator | Zhang, Jian

Quantitative Design of a High Performance Permanent Magnet Vernier Generato...

Archive ouverte: Article de revue

Zhang, Jian | 2017

International audience. Permanent-magnet vernier machines are becoming more and more attractive due to their high torque density and low-speed operating capabilities. This paper investigates the effects of the magne...

Chargement des enrichissements...