Evaluation of a Friction Reduction Based Haptic Surface at High Frequency

Archive ouverte : Communication dans un congrès

Giraud, Frédéric | Hara, Tomohiro | Giraud-Audine, Christophe | Amberg, Michel | Lemaire-Semail, Betty | Takasaki, Masaya

Edité par HAL CCSD

International audience. The influence of the vibration frequency on the friction reduction of an ultrasonic haptic surface has been reported in the literature. The models predict that increasing the frequency of the vibration leads to higher friction reduction at constant vibration amplitude, but this has not been reported experimentally. In this paper, we study the friction reduction on a prototype which can vibrate at low (66kHz) and high (225kHz) frequency. By estimating the Point of Subjective Equivalence between a standard at low frequency with a sample at high frequency, we have found that high frequencies can indeed reduce the friction, with the advantage of much smaller vibration amplitude. Moreover, we show that the invariant between the two frequency conditions is not the vibration amplitude. Our conclusion is that the invariant could be the acceleration instead.

Consulter en ligne

Suggestions

Du même auteur

Preliminary design of a multi-touch ultrasonic tactile stimulator | Ghenna, Sofiane

Preliminary design of a multi-touch ultrasonic tactile stimulator

Archive ouverte: Communication dans un congrès

Ghenna, Sofiane | 2015-06-22

International audience. — This paper presents a method to control ultrasonic waves on a beam, allowing to obtain a Multi-touch ultrasonic tactile stimulation in two points, to give the sensation to two fingers, from...

Vector control method applied to a traveling wave in a finite beam | Giraud, Frédéric

Vector control method applied to a traveling wave in a finite beam

Archive ouverte: Article de revue

Giraud, Frédéric | 2014-01-02

International audience. This paper presents the closed-loop control of exciters to produce a traveling wave in a finite beam. This control is based on a dynamical modeling of the system established in a rotating ref...

Modelling and control of a travelling wave in a finite beam, using multi-modal approach and vector control method | Ghenna, Sofiane

Modelling and control of a travelling wave in a finite beam, using multi-mo...

Archive ouverte: Communication dans un congrès

Ghenna, Sofiane | 2015-04-12

International audience. —This paper presents a new method to produce and control the vibration amplitude and direction of a travelling wave in a finite beam, using multi-modal approach. A closed loop control of the ...

Chargement des enrichissements...