On-wafer differential noise figure measurement without couplers on a vector network analyzer | Andee, Yogadissen
/5

0 avis

On-wafer differential noise figure measurement without couplers on a vector network analyzer

Archive ouverte : Communication dans un congrès

Andee, Yogadissen | Siligaris, Alexandre | Graux, Francois | Danneville, Francois

Edité par HAL CCSD ; IEEE

Isbn; 978-1-4799-7085-8. International audience. This papers presents a measurement technique for the noise figure of on-wafer differential amplifiers using 4-port network analyzers. The approach is based on the determination of the correlation of output noise waves in terms of the 4-port S-parameters and of the output noise powers. The measurement setup is simple as it does not require any hybrid coupler or calibrated noise source. Measurement results of an on-wafer differential LNA demonstrate the validity of the new technique.

Consulter en ligne

Suggestions

Du même auteur

Thermal analysis of ultimately-thinned-and-transfer-bonded CMOS on mechanically flexible foils | Philippe, Justine

Thermal analysis of ultimately-thinned-and-transfer-bonded CMOS on mechanic...

Archive ouverte: Article de revue

Philippe, Justine | 2019-09-06

International audience. Thinned CMOS chips transfer-bonded onto a compliant host substrate remain to date the technology of choice for applications requiring both mechanical flexibility and high frequency operation....

[Invited] Challenges to measure RF noise and intermodulation performances of mmW/THz devices | Danneville, Francois

[Invited] Challenges to measure RF noise and intermodulation performances o...

Archive ouverte: Communication dans un congrès

Danneville, Francois | 2022-07-04

International audience. Applications in millimetre wave range and terahertz frequencies keep on increasing. In this context, drastic challenges are faced at measurement level, in particular to extract noise performa...

Non-linear analysis of a broadband power amplifier at 300 GHz | Ghanem, Haitham

Non-linear analysis of a broadband power amplifier at 300 GHz

Archive ouverte: Communication dans un congrès

Ghanem, Haitham | 2021-01-11

International audience. In this article we present a new method to measure the third-order intercept point (IP3) of a 300 GHz medium power amplifier MMIC based on III-V technology in an on-wafer measurement setup. T...

Du même sujet

New Generation of On-Wafer Microwave Probe Station for Precision GSG Probing | Mokhtari, Cerine

New Generation of On-Wafer Microwave Probe Station for Precision GSG Probin...

Archive ouverte: Communication dans un congrès

Mokhtari, Cerine | 2022-09-12

International audience. Accurate characterization of emergent RF extreme impedance micro-and nanoelectronic devices requires novel probing techniques to ensure the probe-to-pad contact repeatability. In this effort,...

Impact of GSG probe to pads contact repeatability for on-wafer RF measurements | Mokhtari, Cerine

Impact of GSG probe to pads contact repeatability for on-wafer RF measureme...

Archive ouverte: Communication dans un congrès

Mokhtari, Cerine | 2021-08-23

ORAL Session 4A: Medical Instrumentation. International audience. Improving the contact repeatability for on-wafer measurements is required to address accurate characterization of microwave and millimeter-wave extre...

On overtravel and skate in cantilever-based probes for on-wafer measurements | Arscott, S.

On overtravel and skate in cantilever-based probes for on-wafer measurement...

Archive ouverte: Article de revue

Arscott, S. | 2022-05

International audience. Due to the deformability of a microcantilever-based probe, there is an interesting and subtle interplay between the probe overtravel, the tip skate on the surface, and the ultimate tangency o...

RF and Six-Port Microwave Sensing Techniques for Nondestructive Testing and Evaluation | Haddadi, Kamel

RF and Six-Port Microwave Sensing Techniques for Nondestructive Testing and...

Archive ouverte: Communication dans un congrès

Haddadi, Kamel | 2021-08-09

International audience. The physical and mechanical properties of urban structures can be inspected and monitored using nondestructive testing and evaluation (NDT&E) techniques. In particular, microwave methods have...

Identification of Sources of Uncertainties in CW Microwave Noncontact Vital Sign Measurement | Sekak, F.

Identification of Sources of Uncertainties in CW Microwave Noncontact Vital...

Archive ouverte: Communication dans un congrès

Sekak, F. | 2021-11-15

International audience

75 nm gate length PHEMT with f max = 800 GHz using asymmetric gate recess: RF and noise investigation | Samnouni, M.

75 nm gate length PHEMT with f max = 800 GHz using asymmetric gate recess: ...

Archive ouverte: Article de revue

Samnouni, M. | 2021-09

International audience. We report a high maximum frequency of oscillation (f max) and a current-gain cutoff frequency (f T) of 800 and 260 GHz, respectively, with pseudomorphic high-electron mobility transistor (PHE...

Chargement des enrichissements...