Evaluate the influence of starch on earth/hemp or flax straws mixtures properties in presence of superplasticizer

Archive ouverte : Article de revue

Alhaik, Ghaith | Dubois, Vincent | Wirquin, Eric | Leblanc, Alexandre | Aouad, Georges

Edité par HAL CCSD ; Elsevier

International audience. In this paper, we study the influence of two types of starch on earth hemp or flax straw mixtures at fresh and hardened states. The main goal is to propose new non-load bearing earthen for indoor. The mass percentage of starch/binder (S/B) in mixtures was fixed at 1% of mass. The VEBE consistometer test has been used to fix a similar consistency between mixtures. The targeted workability has to allow an easy introduction of materials in the moulds. Adding both of starch has shown a positive effect on mixtures workability at the fresh state and mechanical resistances at the hardened state. At hardened state, mechanical and thermal-acoustic performances have been measured on laboratory samples and blocks at real scale. Results have shown a significant effect of starch on mechanical strengths.

Consulter en ligne

Suggestions

Du même auteur

Evaluate the influence of starch on earth/hemp or flax straws mixtures prop...

Archive ouverte: Article de revue

Alhaik, Ghaith | 2018

In this paper, we study the influence of two types of starch on earth hemp or flax straw mixtures at fresh and hardened states. The main goal is to propose new non-load bearing earthen for indoor. The mass percentage of starch/bin...

Performances of flax shive-based lightweight composites with rapid hardenin...

Archive ouverte: Article de revue

Dubois, Vincent | 2018

This research work aims to develop a rapid hardening lightweight composite including flax shives, foaming agent and earthern materials. The results show a satisfying workability just after the mixing step and a rapid hardening of ...

Effect of mixing conditions on the density, morphology, thermal and mechani...

Archive ouverte: Article de revue

Mazian, Brahim | 2022-07

International audience

Du même sujet

Composite for additive manufacturing including flax byproducts and quarry f...

Archive ouverte: Communication dans un congrès

d'Haese, Romain | 2018-11-01

ACTI. International audience. This study work focus on the development of self-standing insulating wall elements using 3D printingtechnology. Additive manufacturing is promising for the construction industry as it a...

Mechanical behavior of a cementitious composite incorporating flax fibers t...

Archive ouverte: Communication dans un congrès

Freitas-Dutra, Lorena | 2021-08-29

International audience. The building and construction sector is one of the sectors most concerned by the challenges of sustainable development. Indeed, building (construction) represents about 40% of CO2 emissions i...

Chargement des enrichissements...