Computation of Optimal Current References for Flux-weakening of Multi-Phase Synchronous Machines | Lu, Li
/5

0 avis

Computation of Optimal Current References for Flux-weakening of Multi-Phase Synchronous Machines

Archive ouverte : Communication dans un congrès

Lu, Li | Aslan, Bassel | Kobylanski, Luc | Sandulescu, Paul | Meinguet, Fabien | Kestelyn, Xavier | Semail, Eric

Edité par HAL CCSD

International audience. Multi-phase synchronous machines are more and more used in specific applications where high power density, low bus voltage, wide speed range and fault-tolerant capabilities are required. Due to the high number of degrees of freedom, multi-phase machines are difficult to optimally operate in flux-weakening zones. This paper proposes a technique to numerically compute optimal current references that can be used for feed-forward flux-weakening techniques in order to exploit the maximum machine performances for given DC bus voltage and current limits. The proposed technique is applied to a five-phase permanent magnet synchronous machine specifically developed for an automotive application.

Consulter en ligne

Suggestions

Du même auteur

Signal-based Technique for Fault Detection and Isolation of Inverter Faults in Multi-phase Drives | Meinguet, Fabien

Signal-based Technique for Fault Detection and Isolation of Inverter Faults...

Archive ouverte: Communication dans un congrès

Meinguet, Fabien | 2012-12-17

International audience. A method for fault detection and isolation is proposed and applied to inverter faults in multi-phase drives. An analysis of simulations in faulty conditions leads to the derivation of suitabl...

Different Virtual Stator Winding Configurations of Open-End Winding Five-Phase PM Machines for Wide Speed Range without Flux Weakening Operation | Nguyen, N.K

Different Virtual Stator Winding Configurations of Open-End Winding Five-Ph...

Archive ouverte: Communication dans un congrès

Nguyen, N.K | 2013-09-03

International audience. This paper presents a specific control strategy of double-ended inverter system for wide-speed range of open-winding five phase PM machines. Different virtual winding configurations (star, pe...

Flux-Weakening Strategies for a Five-Phase PM Synchronous Machine | Lu, Li

Flux-Weakening Strategies for a Five-Phase PM Synchronous Machine

Archive ouverte: Communication dans un congrès

Lu, Li | 2011-09

International audience. In order to get a low cost mild hybrid system, a global objective is to keep the actual thermal engine architecture. As consequence, the current clawpole synchronous automotive generator must...

Du même sujet

Flux-Weakening Strategies for a Five-Phase PM Synchronous Machine | Lu, Li

Flux-Weakening Strategies for a Five-Phase PM Synchronous Machine

Archive ouverte: Communication dans un congrès

Lu, Li | 2011-09

International audience. In order to get a low cost mild hybrid system, a global objective is to keep the actual thermal engine architecture. As consequence, the current clawpole synchronous automotive generator must...

Design Considerations of Five-Phase Machine with Double p/3p Polarity | Gong, Jinlin

Design Considerations of Five-Phase Machine with Double p/3p Polarity

Archive ouverte: Article de revue

Gong, Jinlin | 2018

International audience. In the context of traction drives with required torque transient capabilities and a classically wide flux weakening speed range, this paper gives design considerations of a particularDouble-P...

Comparison of Optimized Control Strategies of a High-Speed Traction Machine with Five Phases and Bi-Harmonic Electromotive Force | Zahr, Hussein

Comparison of Optimized Control Strategies of a High-Speed Traction Machine...

Archive ouverte: Article de revue

Zahr, Hussein | 2016-11-25

International audience. The purpose of the paper is to present the potentialities in terms of the control of a new kind of PM synchronous machine. With five phases and electromotive forces whose first (E1) and third...

Inductances and back-emf harmonics influence on the Torque/Speed characteristic of five-phase SPM machine | Scuiller, Franck

Inductances and back-emf harmonics influence on the Torque/Speed characteri...

Archive ouverte: Communication dans un congrès

Scuiller, Franck | 2014-10

In this paper, the study of torque/speed characteristic for five-phase Surface-mounted Permanent Magnet (SPM) machine is carried out. With considering several hypothesis (linear magnetic modelling, only first and third harmonic te...

Variable speed Control under Voltage and Current Limits of a 5-phase PMSM drive in Healthy and Open-Circuited Modes | Fall, Ousmane

Variable speed Control under Voltage and Current Limits of a 5-phase PMSM d...

Archive ouverte: Article de revue

Fall, Ousmane | 2016-06

International audience. This paper proposes a novel variable speed control strategy of a particular 5-phase Permanent Magnet Synchronous Generator (PMSG) in healthy and faulty modes by taking into account the constr...

Maximum reachable torque, power and speed for five-phase SPM machine with low armature reaction | Scuiller, Franck

Maximum reachable torque, power and speed for five-phase SPM machine with l...

Archive ouverte: Article de revue

Scuiller, Franck | 2016

International audience. Abstract—In this paper, the study of the torque and power versus speed characteristics for a family of five-phase Surface-mounted Permanent Magnet (SPM) machine is carried out. With consideri...

Chargement des enrichissements...