Determination of Mixing Times with Helical Ribbon Impeller for Non-Newtonian Viscous Fluids Using an Advanced Imaging Method | Chhabra, R.
/5

0 avis

Determination of Mixing Times with Helical Ribbon Impeller for Non-Newtonian Viscous Fluids Using an Advanced Imaging Method

Archive ouverte : Article de revue

Chhabra, R. | Bouvier, L. | Delaplace, Guillaume | Cuvelier, G. | Domenek, S. | André, C.

Edité par HAL CCSD

New results on mixing times for viscous Newtonian and non-Newtonian fluids being homogenized with a helical ribbon impeller are presented. In particular, a recently developed technique to determine the macromixing kinetics of an impeller in a transparent vessel was applied to investigate the effects of rheological properties on mixing times. Significant differences were observed in the mixing times for viscous Newtonian and non-Newtonian fluids. Based on the new data obtained in this work, a correlation incorporating the elastic effects is proposed in terms of a Weissenberg number for predicting the mixing time as a function of the Reynolds number and the system geometry.

Consulter en ligne

Suggestions

Du même auteur

Influence of Rheological Behavior of Purely Viscous Fluids on Analytical Residence Time Distribution in Straight Tubes | Delaplace, Guillaume

Influence of Rheological Behavior of Purely Viscous Fluids on Analytical Re...

Archive ouverte: Article de revue

Delaplace, Guillaume | 2008-02

In an effort to better understand the homogeneity of heat treatment of foodstuffs in holding tubes, the cumulative residence time distribution function is derived for a Herschel-Bulkley fluid from fully developed laminar flow in a...

Dimensional analysis for planetary mixer: Mixing time and Reynolds numbers | Delaplace, Guillaume

Dimensional analysis for planetary mixer: Mixing time and Reynolds numbers

Archive ouverte: Article de revue

Delaplace, Guillaume | 2007-03

Mixing time number is a convenient parameter to characterize mixing performance of stirred tanks. This dimensionless number is now well established for agitated vessels equipped with vertically and centrally mounted impeller for N...

Experimental and CFD Simulation of Heat Transfer to Highly Viscous Fluids in an Agitated Vessel Equipped With a non Standard Helical Ribbon Impeller | Delaplace, Guillaume

Experimental and CFD Simulation of Heat Transfer to Highly Viscous Fluids i...

Archive ouverte: Article de revue

Delaplace, Guillaume | 2001-11

Du même sujet

Dimensional analysis for planetary mixer: Mixing time and Reynolds numbers | Delaplace, Guillaume

Dimensional analysis for planetary mixer: Mixing time and Reynolds numbers

Archive ouverte: Article de revue

Delaplace, Guillaume | 2007-03

Mixing time number is a convenient parameter to characterize mixing performance of stirred tanks. This dimensionless number is now well established for agitated vessels equipped with vertically and centrally mounted impeller for N...

Power requirement for mixing shear-thinning fluids with a planetary mixer | Auger, F.

Power requirement for mixing shear-thinning fluids with a planetary mixer

Archive ouverte: Article de revue

Auger, F. | 2015

The optimal control of processes dealing with non-Newtonian liquids requires the knowledge and control of the power demand of the mixing equipment. In this context, an extension of the Metzner and Otto concept to planetary mixers ...

Dimensional analysis of a planetary mixer for homogenizing of free flowing powders: Mixing time and power consumption | Andre, C.

Dimensional analysis of a planetary mixer for homogenizing of free flowing ...

Archive ouverte: Article de revue

Andre, C. | 2012-08

International audience. Powder mixing is crucial to the processing stages in many industries. However, there is still a paucity of information about the effects of process parameters on mixing efficiency. This paper...

Hydrodynamics of a planetary mixer used for dough process: Influence of impeller speeds ratio on the power dissipated for Newtonian fluids | Auger, Frederic

Hydrodynamics of a planetary mixer used for dough process: Influence of imp...

Archive ouverte: Article de revue

Auger, Frederic | 2013

The objective of this paper is to better characterize the influence of process parameters (impeller revolution speeds) on the performance of a planetary flour-beater mixer (mixer bowl P600 from Brabender) used in dough production....

An arrangement of ideal reactors as a way to model homogenizing processes with a planetary mixer | Delaplace, Guillaume

An arrangement of ideal reactors as a way to model homogenizing processes w...

Archive ouverte: Article de revue

Delaplace, Guillaume | 2011-07

This article investigates ways of modeling the homogenization mechanism occurring when mixing highly viscous Newtonian fluids with a planetary mixer. In particular, an arrangement of ideal reactors containing a perfect‐mixed zone ...

Chargement des enrichissements...