Relevance of a novel external dynamic distraction device for treating back pain.

Archive ouverte : Article de revue

Zaïri, Fahed | Moulart, Mélissa | Fontaine, Christian | Zaïri, Fahmi | Tiffreau, Vincent | Logier, Régis

Edité par HAL CCSD ; Sage

Low back pain is a common, expensive, and disabling condition in industrialized countries. There is still no consensus for its ideal management. Believing in the beneficial effect of traction, we developed a novel external dynamic distraction device. The purpose of this work was to demonstrate that external distraction allows limiting the pressure exerted in standing-up position on the lower intervertebral discs. Numerical and cadaveric studies were used as complementary approaches. Firstly, we implemented the device into a numerical model of a validated musculoskeletal software (Anybody Modeling System) and we calculated the lower disc pressure while traction forces were applied. Secondly, we performed an anatomical study using a non-formalin preserved cadaver placed in a sitting position. A pressure sensor was placed in the lower discs under fluoroscopic control through a Jamshidi needle. The intradiscal pressure was then measured continuously at rest while applying a traction force of 200 N. Both numerical and cadaveric studies demonstrated a decrease in intradiscal pressures after applying a traction force with the external device. Using the numerical model, we showed that tensile forces below 500 N in total were sufficient. The application of higher forces seems useless and potentially deleterious. External dynamic distraction device is able to significantly decrease the intradiscal pressure in a sitting or standing position. However, the therapeutic effects need to be proven using clinical studies.

Consulter en ligne

Suggestions

Du même auteur

Médecine physique et de réadaptation / sous l'égide du Collège français des...

Livre | Tiffreau, Vincent (1972-....). Directeur de publication | 2021 - 7e édition

Publié dans la collection Référentiels des collèges, en parfaite conformité avec le programme de DFASM (diplôme de formation approfondie en sciences médicales) s'inscrivant dans la R2C 2021, cet ouvrage rassemble l'ensemble des co...

Modeling strain-induced dual-phase transformation in semicrystalline polyla...

Archive ouverte: Article de revue

Mahjoubi, Hanen | 2022-08-16

International audience. Polylactic acid or polylactide (PLA) can form amorphous, semicrystalline, or highly crystalline structure. In this paper, we provide a model for semicrystalline PLA under straininduced dual-p...

Fracture behavior of Alumina-Tricalcium phosphate-Titania composites for bo...

Archive ouverte: Article de revue

Barkallah, Rachida | 2021-10

International audience

Du même sujet

Global modeling of different vehicles, using Energetic Macroscopic Represen...

Archive ouverte: Article de revue

Chen, Keyu | 2009-01-01

To optimize the operation of internal combustion engine (ICE), maximize fuel economy, and minimize emissions, many novel traction schemes have been developed. Among those, an electromechanical converter known as electric variable ...

Low back pain in patients with multiple sclerosis: A systematic review and ...

Archive ouverte: Article de revue

Massot, Caroline | 2021-04

International audience. PurposeThe prevalence and management of back pain in MS patients was assessed by a systematic review, and the results of a survey on the characteristics of low back pain in a sample of French...

Vector control method applied to a traveling wave in a finite beam

Archive ouverte: Article de revue

Giraud, Frédéric | 2014-01-02

International audience. This paper presents the closed-loop control of exciters to produce a traveling wave in a finite beam. This control is based on a dynamical modeling of the system established in a rotating ref...

Improving the PAD actuator performances by vector control

Archive ouverte: Article de revue

Giraud-Audine, Christophe | 2018-12

International audience. In this work, we address the problem of pull-out and stalling of the vector control of the piezo-actuator drive (PAD). The model presented reveals the similarities with synchronous machine an...

Graphical description for inversion-based control of hybrid electric vehicl...

Archive ouverte: Communication dans un congrès

Bouscayrol, Alain | 2008-08-11

EET-2008 European Ele-Drive Conference - International Advanced Mobility Forum, GENEVE, SUISSE, 11-/08/2008 - 13/08/2008. The French national MEGEVH project deals with energy management of hybrid electric vehicles (...

Energetique Macroscopique Representation of subway VAL 206 and deduced inve...

Archive ouverte: Thèse

Verhille, Jean-Noël | 2007-07-04

Subway VAL 206 including several machines and/or converters belongs to the Multimachines Multiconverters Systems family (MMS). These systems are defined by several devices with common physical parts between energy conversion eleme...

Chargement des enrichissements...