Homopolar Current’s Copper Losses Analysis for Different Modulations in Open-End Winding Five-Phase drives | dos Santos Moraes, Tiago José
/5

0 avis

Homopolar Current’s Copper Losses Analysis for Different Modulations in Open-End Winding Five-Phase drives

Archive ouverte : Communication dans un congrès

dos Santos Moraes, Tiago José | Trabelsi, Mohamed | Zahr, Hussein | Semail, Eric

Edité par HAL CCSD ; IEEE

International audience. This paper analyses the copper losses due to the homopolar current of a five-phase open-end winding machine supplied by a 10-leg inverter and a single DC voltage source. This topology can have non-null high frequency homopolar current components that can increase the machine’s copper losses and result in overheating of the motor phase windings. Accordingly, different modulation strategies are compared with the goal of reducing the homopolar current and, consequently the resulting copper losses. The comparison study is achieved using Matlab/Simulink and a finite element model in order to evaluate these losses.

Consulter en ligne

Suggestions

Du même auteur

Demagnetization analysis of an open-end windings 5-phase PMSM under transistor short-circuit fault | dos Santos Moraes, Tiago José

Demagnetization analysis of an open-end windings 5-phase PMSM under transis...

Archive ouverte: Communication dans un congrès

dos Santos Moraes, Tiago José | 2019-10-14

International audience. For an open-end windings integrated Permanent Magnet Synchronous Machine, the demagnetization of the permanent magnets is analyzed when a transistor is short-circuited and no specific control...

A Comparative Study of Two Fault-Tolerant Dual-Motor Drive Topologies Under Short-Circuit Inverter Switch Fault | dos Santos Moraes, Tiago José

A Comparative Study of Two Fault-Tolerant Dual-Motor Drive Topologies Under...

Archive ouverte: Communication dans un congrès

dos Santos Moraes, Tiago José | 2015-06

International audience. This paper analyzes two dual-motor fault-tolerant topologies for aerospace thruster application. The first structure supplies independently both machines while the second one connects them in...

Generalized Vectorial Formalism – based multiphase series-connected motors control | Semail, Eric

Generalized Vectorial Formalism – based multiphase series-connected motors ...

Archive ouverte: Communication dans un congrès

Semail, Eric | 2015-10

Multiphase drives are more and more used in specific applications leading to a necessity of control strategy development. This paper presents the Generalized Vectorial Formalism (GVF) theory to control multiphase series-connected ...

Du même sujet

A Simple Carrier-Based Modulation for the SVM of the Matrix Converter | Gruson, François

A Simple Carrier-Based Modulation for the SVM of the Matrix Converter

Archive ouverte: Article de revue

Gruson, François | 2013-05

International audience. Today, industry has not fully embraced the matrix converter solution. One important reason is its high control complexity. It is therefore relevant to propose a simpler but efficient modulati...

Different Virtual Stator Winding Configurations of Open-End Winding Five-Phase PM Machines for Wide Speed Range without Flux Weakening Operation | Nguyen, N.K

Different Virtual Stator Winding Configurations of Open-End Winding Five-Ph...

Archive ouverte: Communication dans un congrès

Nguyen, N.K | 2013-09-03

International audience. This paper presents a specific control strategy of double-ended inverter system for wide-speed range of open-winding five phase PM machines. Different virtual winding configurations (star, pe...

Electric Vehicles Driven by 5-phase Open-End Winding Machines Fed by Battery and Supercapacitors | Vu, Duc Tan

Electric Vehicles Driven by 5-phase Open-End Winding Machines Fed by Batter...

Archive ouverte: Communication dans un congrès

Vu, Duc Tan | 2019-10-15

International audience. This paper presents the modeling and control of an Electric Vehicle (EV) driven by a 5-phase Permanent Magnet Synchronous Machine (PMSM). The machine in an open-end winding configuration is s...

Comparison of five-phase, six-phase and seven-phase fault tolerant electric drives | Ribiere, Antonin

Comparison of five-phase, six-phase and seven-phase fault tolerant electric...

Archive ouverte: Communication dans un congrès

Ribiere, Antonin | 2022-06

International audience. Automotive industry is evolving towards more fault-tolerant actuators to fulfill future autonomous vehicles requirements. Critical applications such as steering or braking have to resist to f...

Fault-Tolerant Operation of an Open-End Winding Five-Phase PMSM Drive with Short-Circuit Inverter Fault | Nguyen, Ngac Ky

Fault-Tolerant Operation of an Open-End Winding Five-Phase PMSM Drive with ...

Archive ouverte: Article de revue

Nguyen, Ngac Ky | 2015-01

International audience. Multi-phase machines are well-known for their fault tolerant capability. Star-connected multiphase machines have fault tolerance in open-circuit. For inverter switch short-circuitfault, it is...

Iterative Solvers for Singular Symmetric Linear Systems in Low Frequency Electromagnetics | Tinzefte, Abdellatif

Iterative Solvers for Singular Symmetric Linear Systems in Low Frequency El...

Archive ouverte: Article de revue

Tinzefte, Abdellatif | 2009-03-01

International audience. In this paper, several methods based on Krylov methods are proposed to solve the singular linear systems from finite element method. Indeed, in the magnetostatic case, for A-formulation the s...

Chargement des enrichissements...