Electric Vehicles Driven by 5-phase Open-End Winding Machines Fed by Battery and Supercapacitors | Vu, Duc Tan
/5

0 avis

Electric Vehicles Driven by 5-phase Open-End Winding Machines Fed by Battery and Supercapacitors

Archive ouverte : Communication dans un congrès

Vu, Duc Tan | Nguyen, Ngac Ky | Semail, Eric | Lhomme, Walter

Edité par HAL CCSD ; IEEE

International audience. This paper presents the modeling and control of an Electric Vehicle (EV) driven by a 5-phase Permanent Magnet Synchronous Machine (PMSM). The machine in an open-end winding configuration is supplied by two isolated 5-leg Voltage Source Inverters (VSIs). The inverters are fed by a Hybrid Energy Storage System (HESS) consisting of a battery and Supercapacitors (SCs).To increase the battery lifetime, the SCs are used to provide the high-power requirement during driving operations. In addition, an Energy Management Strategy (EMS) is proposed to take advantages of this EV architecture. Numerical results are derived to verify workability of the EV system.

Consulter en ligne

Suggestions

Du même auteur

Fault-tolerant control of non-sinusoidal multiphase permanent magnet synchronous machine drives under constraints on current and voltage for automotive applications. Commande tolérante aux défauts des entraînements de machines synchrones à aimants permanents polyphasées non-sinusoïdales sous contraintes de courant et de tension pour les applications automobiles | Vu, Duc Tan

Fault-tolerant control of non-sinusoidal multiphase permanent magnet synchr...

Archive ouverte: Thèse

Vu, Duc Tan | 2020-11-24

Electric drives for electrified vehicles need to fulfil some specific requirements from automotive markets such as high efficiency, high volume power and torque densities, low-cost but safe-to-touch, high functional reliability, h...

An Overview of Methods using Reduced-Ordered Transformation Matrices for Fault-Tolerant Control of 5-phase Machines with an Open Phase | Vu, Duc Tan

An Overview of Methods using Reduced-Ordered Transformation Matrices for Fa...

Archive ouverte: Communication dans un congrès

Vu, Duc Tan | 2019-02-13

International audience. This paper studies control strategies using modified transformation matrices when five-phase machines operate in oneopen-phase faults. The basic idea of these methods is to maintain the rotat...

Fault-tolerant Control for Non-sinusoidal Multiphase Drives with Minimum Torque Ripple | Vu, Duc Tan

Fault-tolerant Control for Non-sinusoidal Multiphase Drives with Minimum To...

Archive ouverte: Article de revue

Vu, Duc Tan | 2021-12-09

International audience. For non-sinusoidal electromotive force (NS-EMF) multiphase machines, this paper proposes a new strategy and control scheme to guarantee smooth torque under an open-phase fault. Notably, the c...

Du même sujet

Comparison of five-phase, six-phase and seven-phase fault tolerant electric drives | Ribiere, Antonin

Comparison of five-phase, six-phase and seven-phase fault tolerant electric...

Archive ouverte: Communication dans un congrès

Ribiere, Antonin | 2022-06

International audience. Automotive industry is evolving towards more fault-tolerant actuators to fulfill future autonomous vehicles requirements. Critical applications such as steering or braking have to resist to f...

Difference between average efficiency and efficiency map of the electric drive on fuel saving estimation for P-HEV | Tournez, Florian

Difference between average efficiency and efficiency map of the electric dr...

Archive ouverte: Communication dans un congrès

Tournez, Florian | 2021-10-25

International audience. Retrofit electrification of engine-powered vehicles to plug-in hybrid electric vehicles is growing. Different hybrid solutions exist, but all of them must compromise between integration const...

Fault-Tolerant Operation of an Open-End Winding Five-Phase PMSM Drive with Short-Circuit Inverter Fault | Nguyen, Ngac Ky

Fault-Tolerant Operation of an Open-End Winding Five-Phase PMSM Drive with ...

Archive ouverte: Article de revue

Nguyen, Ngac Ky | 2015-01

International audience. Multi-phase machines are well-known for their fault tolerant capability. Star-connected multiphase machines have fault tolerance in open-circuit. For inverter switch short-circuitfault, it is...

Eliminations of Low-frequency Current Harmonics for Five-phase Open-end Winding Non-sinusoidal Machine Drives applying Neural Networks | Vu, Duc Tan

Eliminations of Low-frequency Current Harmonics for Five-phase Open-end Win...

Archive ouverte: Communication dans un congrès

Vu, Duc Tan | 2020-10-18

International audience. This study aims at eliminating unwanted harmonics in current control of a five-phase non-sinusoidal permanent magnet synchronous machine (PMSM) in an open-end winding configuration. The machi...

Fault-Tolerant Operation of an Open-End Winding Five-Phase PMSM Drive with Inverter Faults | Meinguet, Fabien

Fault-Tolerant Operation of an Open-End Winding Five-Phase PMSM Drive with ...

Archive ouverte: Communication dans un congrès

Meinguet, Fabien | 2013-12-10

The authors would like to thank the ADEME for the funding of the MHYGALE project.. Multi-phase machines are known for their fault-tolerant capability. However, star-connected machines have no fault tolerance to inve...

Different Virtual Stator Winding Configurations of Open-End Winding Five-Phase PM Machines for Wide Speed Range without Flux Weakening Operation | Nguyen, N.K

Different Virtual Stator Winding Configurations of Open-End Winding Five-Ph...

Archive ouverte: Communication dans un congrès

Nguyen, N.K | 2013-09-03

International audience. This paper presents a specific control strategy of double-ended inverter system for wide-speed range of open-winding five phase PM machines. Different virtual winding configurations (star, pe...

Chargement des enrichissements...