Comparison between a Double Excitation Synchronous Machine and a Permanent Magnet Synchronous Machine According to Various Constant Power Speed Ranges

Archive ouverte : Communication dans un congrès

Hoang, Trung-Kien | Gabsi, M. | Vido, L | Gillon, F

Edité par HAL CCSD

International audience. This paper presents a comparison between a Double Excitation Synchronous Machine (DESM) and a Permanent Magnet Synchronous Machine (PMSM). Optimal designs of both machine types are compared regarding different constant power speed ranges (CPSR). The optimization objectives are to minimize the active material cost and losses. Results show that the DESM is more advantageous over the PMSM counterpart in loss saving at a wide CPSR, and the PMSM is capable of reducing the machine cost.

Consulter en ligne

Suggestions

Du même auteur

Geometry optimization to increase the flux control range of a double excitation synchronous motor | Hoang, Trung-Kien

Geometry optimization to increase the flux control range of a double excita...

Archive ouverte: Communication dans un congrès

Hoang, Trung-Kien | 2017-07-04

International audience. This paper deals with a structural optimization to improve the open circuit flux control capability of a double excitation synchronous motor. In this kind of motor, the air-gap flux varies ac...

Thermal analysis of a double excitation synchronous machine | Hoang, Trung-Kien

Thermal analysis of a double excitation synchronous machine

Archive ouverte: Communication dans un congrès

Hoang, Trung-Kien | 2017-07-04

International audience. In this paper, a thermal analysis of a synchronous machine using the double excitation principle is presented. Two global field windings introduce not only a more complicated structure but al...

Correction to “Flux Control Range Broadening and Torque Ripple Minimization of a Double Excitation Synchronous Motor” [Jan 17 Art. no. 8100510] | Hoang, Trung-Kien

Correction to “Flux Control Range Broadening and Torque Ripple Minimization...

Archive ouverte: Article de revue

Hoang, Trung-Kien | 2017-05

International audience. I N [1], an error in Fig. 2 in Section II-B is corrected. In the original figure, Fig. 2(b) was exactly the same as Fig. 2(a). The correction is shown here. Fig. 2. RN model of the prototype....

Chargement des enrichissements...