Experimental insight into the third-order intercepts and nonlinear distortion of GaN HEMTs

Archive ouverte : Article de revue

Alim, Mohammad A. | Ali, Mayahsa M. | Gaquière, Christophe

Edité par HAL CCSD ; Wiley

International audience. This research is about investigating the third-order intercept point (TOI) and nonlinear distortion level (NDL) for two GaN HEMTs of different gate lengths with temperature and frequency. As a multi-biasing, input power, frequency and temperature-dependent term; the TOI point and as well as the nonlinear distortion level are particular figures merit relevant to the third-order intermodulation distortion (IMD3) product. The primary results are the output referenced TOI reduced whereas the input referenced TOI raised as the frequency goes higher and the lower gated device exhibits a bit greater magnitude. Over the temperature range measured; the magnitude of TOI and nonlinear distortion considerably changed in accordance to the performance of third order intermodulation distortion (IMD3) component. This investigation of TOI is used to determine what extent distortion is generated, and comparing that to the entryway of the antenna provides a clear strategy for determining if the spec can be met or not. However, distortion level investigation is a critical point to choose the best biasing preference with the device's inlet measurements to establish a solution that fits with the intended usage.

Consulter en ligne

Suggestions

Du même auteur

220 GHz E-Plane Transition from Waveguide to Suspended Stripline Integrated on Industrial Organic Laminate Substrate Technology | Fiorese, Victor

220 GHz E-Plane Transition from Waveguide to Suspended Stripline Integrated...

Archive ouverte: Communication dans un congrès

Fiorese, Victor | 2021-04-02

International audience. In this paper, an assessment up to 220 GHz of industrial organic laminate substrate technology to integrate millimeter-wave (mmW) waveguide to suspended stripline (SSL) transition is proposed...

A 140 GHz to 170 GHz active tunable noise source development in SiGe BiCMOS 55 nm technology | Fiorese, Victor

A 140 GHz to 170 GHz active tunable noise source development in SiGe BiCMOS...

Archive ouverte: Communication dans un congrès

Fiorese, Victor | 2022-04-03

oral EuMIC08-5Session EuMIC08 - Components and Subsystems for 100 GHz and Above. International audience. A new approach of millimeter wave (mmW) integrated active noise source (NS) is introduced for noise characteri...

Substrate engineering of inductors on SOI for improvement of Q-factor and application in LNA | Bhaskar, Arun

Substrate engineering of inductors on SOI for improvement of Q-factor and a...

Archive ouverte: Article de revue

Bhaskar, Arun | 2020-08-27

Renatech Network, Laboratoire commun ST-Microelectronics - IEMN. International audience. High Q-factor inductors are critical in designing high performance RF/microwave circuits on SOI technology. Substrate losses i...

Du même sujet

Morphological, structural, electrical, and piezoelectric analysis of hydrothermally grown ZnO nanowires on various substrates | Hamdi, Abderrahmane

Morphological, structural, electrical, and piezoelectric analysis of hydrot...

Archive ouverte: Article de revue

Hamdi, Abderrahmane | 2022-07

International audience. In this present work, we have successfully fabricated a piezoelectric structure based on ZnO nanowires (ZnO NWs) using a simple, low cost and environmentally friendly hydrothermal method. Thi...

Self-heating temperature measurement in AlInN/GaN HEMTs by using CeO2 and TiO2 micro-raman thermometers | Strenaer, R.

Self-heating temperature measurement in AlInN/GaN HEMTs by using CeO2 and T...

Archive ouverte: Article de revue

Strenaer, R. | 2022-11

International audience. Thermal characterization of GaN-based components is an important and challenging issue that requires the measurement of the self-heating temperature of the channel, the metal contact surface ...

Development of a CMOS-compatible carbon nanotube array transfer method | Siah, Chun,

Development of a CMOS-compatible carbon nanotube array transfer method

Archive ouverte: Article de revue

Siah, Chun, | 2021-01-18

International audience. Carbon nanotubes (CNTs) have, over the years, been used in research as a promising material in electronics as a thermal interface material and as interconnects amongst other applications. How...

Electromechanical properties of sodium bismuth titanate thin films | Kossman, Stephania

Electromechanical properties of sodium bismuth titanate thin films

Archive ouverte: Article de revue

Kossman, Stephania | 2022-10-01

International audience. Lead-free piezoelectric sodium bismuth titanate (BNT) films are promising candidates for actuators applications as an alternative to lead zirconate titanate films. We focused in this work on ...

Experimental set up for magnetomechanical measurements with a closed flux path sample | El Youssef, Mohamad

Experimental set up for magnetomechanical measurements with a closed flux p...

Archive ouverte: Article de revue

El Youssef, Mohamad | 2020-08-28

International audience. In this article, an experimental procedure is presented to handle magnetic measurements under uniaxial tensile stress reaching the plastic domain. The main advantage of the proposed procedure...

Characterization of the Local Incremental Permeability of a Ferromagnetic Plate Based on a Four Needles Technique | Arbenz, Laure

Characterization of the Local Incremental Permeability of a Ferromagnetic P...

Archive ouverte: Article de revue

Arbenz, Laure | 2016

International audience. The performances of electrical machines depend highly on the behavior of ferromagnetic materials. In some applications, these materials operate under DC polarization, i.e. when the magnetic f...

Chargement des enrichissements...